Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 408)

394 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
MAC Extended ACL Config Commands
16
no
MAC Extended ACL Config Commands
Use this command to negate a command or set defaults.
Syntax
no(deny|mark|permit)
This command negates all the syntax combinations used in deny , mark and permit to configure the
Extended ACL.
Parameters
Example
RFS7000(config-ext-macl)#no mark tos 254 host 00:33:44:55:66:77 any type ip
rule-precedence 50
RFS7000(config-ext-macl)#
RFS7000(config-ext-macl)#no deny any any vlan 5 type 8021q rule-precedence 10
RFS7000(config-ext-macl)#
RFS7000(config-ext-macl)#no permit any any type wisp rule-precedence 50
RFS7000(config-ext-macl)#
deny Specifies packets to reject.
mark Specifies packets to mark.
permit Specifies packets to forward.