Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 440)

426 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
DHCP Config Commands
17
network
DHCP Config Commands
Use this command to configure the network pool’s IP address. This maps the current DHCP pool
with the specific network.
Syntax
network [A.B.C.D|A.B.C.D/M]
Parameters
Usage Guidelines
Ensure a VLAN interface with specific network /subnet exists on the switch before mapping the
DHCP pool to a particular network.
Example
RFS7000(config-dhcp)#network 2.2.2.0/24
RFS7000(config-dhcp)#
network
[A.B.C.D|A.B.C.D/M] Network number and mask.
•
A.B.C.D – Network number in dotted decimal format.
•
A.B.C.D/M – Network number and mask.