Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 569)

Brocade Mobility RFS7000-GR Controller CLI Reference Guide 555
53-1001945-01
Wireless Configuration Commands
20
Example
RFS7000(config-wireless)#wlan 1 aap-proxy-radius enable
Note: aap-radius-proxy must only be enabled when external radius server is usedDo
not enable this feature, when the switch onboard radius server is used.
RFS7000(config-wireless)#
RFS7000(config-wireless)#wlan 25 accounting syslog
RFS7000(config-wireless)#
RFS7000(config-wireless)#wlan 25 answer-bcast-ess
RFS7000(config-wireless)#
RFS7000(config-wireless)#wlan 25 authentication-type kerberos
RFS7000(config-wireless)#
RFS7000(config-wireless)#wlan 25 description "TestWLAN"
RFS7000(config-wireless)#
RFS7000(config-wireless)#wlan 25 dot11i handshake timeout 2500 retransmit 5
RFS7000(config-wireless)#
RFS7000(config-wireless)#wlan 25 dot11i key-rotation enable
RFS7000(config-wireless)#
RFS7000(config-wireless)#wlan 25 dot11i key-rotation-interval 2000
RFS7000(config-wireless)#
RFS7000(config-wireless)#wlan 25 enable
RFS7000(config-wireless)#
RFS7000(config-wireless)#wlan 25 hotspot webpage external failure "This feature
is under development"
smart-scan-channel
[WORD|add|remove] Specifies a list channels to Brocade clients to do smart scan.
•
WORD – A comma-separated list of channels.
•
add <WORD> – Adds one or more channels to existing channel list.
•
remove <WORD> – Removes one or more channels to existing channel list.
ssid The SSID of this WLAN.
storm-control
[bcast|macast|ucast] Storm control
•
bcast (rate-limit <1-1000000>) – broadcast.
•
mcast (rate-limit <1-1000000>) – multicast.
•
ucast (rate-limit <1-1000000>) – unicast.
•
rate-limit <1-1000000> – Does packet ratelimiting.
•
<1-1000000> – Allowed rate in packets/sec
syslog (accounting)
server <IP Address>
port <Port number> Syslog Accounting.
•
accounting – Modifies accounting parameters.
•
server <IP Address> – Modifies syslog accounting server IP address.
•
port <Port Number> – Syslog server port. The default port is 514.
url-log (enable) Enables HTTP-ALG on WLAN(s)
vlan<1-4094> [limit
range<0-8192>] The VLAN assignment of this WLAN. This command starts a new VLAN assignment
for given WLAN index. All prior VLAN settings will be erased.
•
[<1-4094>|VLAN] – VLAN range list. It can be either a single index or a list
(eg: 1,3,7) or range (eg: 3-7) of indices.
•
limit – Set user limits on vlans for this WLAN in a range of the value
<0-8192>.