Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 318)

304 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
Trustpoint Config commands
11
no
Trustpoint Config commands
Use this command to negate a command or set defaults.
Syntax
no [company-name|email|fqdn|ip-address|subject-name]
Parameters
Example
RFS7000(config-trustpoint)#no ip-address
RFS7000(config-trustpoint)#
company-name Negates the configured company name.
email Negates email address
fqdn Negates Domain Name Configuration (DNS).
ip-address Negates Internet Protocol (IP)
subject-name Negates subject name, which is a collection of required parameters to configure a
trustpoint.
It comprises of common_name, country, state, organization,org name etc.