Wips – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual

Page 557

Advertising
background image

Brocade Mobility RFS7000-GR Controller CLI Reference Guide

543

53-1001945-01

Wireless Configuration Commands

20

wips

Wireless Configuration Commands

Use this command to configure parameters related to WIPS.

Syntax

wips [detect-window|disable|event|reset-to-default]

wips detect-window <5-300>

wips event [80211-replay-check-failure|ad-hoc-advertising-authorized-ssid|

ad-hoc-network-violation-authorized-device|

ad-hoc-network-violation-unauthorized-device|aggressive-scanning|all|

ap-default-configuration|ap-ssid-broadcast-in-beacon|

crackable-wep-iv-key-used |decryption-failures|

dos-association-or-authentication-flood|

dos-broadcast-deauthentication|dos-eapol-start-storm|

dos-unicast-deauthentication-or-disassociation|eap-flood|eap-nak-flood|

failures-reported-by-authentication-servers|fake-ap-flood|

frames-from-unassociated-stations|frames-with-bad-essids|

fuzzing-all-zero-mac-address-observed|fuzzing-invalid-frame-type-detected|

fuzzing-invalid-management-frame|fuzzing-invalid-sequence-number|

identical-source-and-destination-addresses|impersonation-attack-detected|

invalid-8021x-frames| non-changing-wep-iv|replay-injection-attack|

tkip-mic-counter-measures-caused-by-station|

transmitting-device-using-invalid-mac|

unauthorized-ap-using-authorized-ssidunencrypted-station-transmission-detect

ed]

Parameters

detect-window <5-300>

Sets the number of seconds for which information is collected before analysis.All the
thresholds are function of this window size.

disable

Disables WIPS without affecting the configuration.

Advertising