Default-router – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 429
Advertising
Brocade Mobility RFS7000-GR CLI Reference Guide
415
53-1001945-01
DHCP Config Commands
17
default-router
Use this command to configure the default router or gateway IP address for the network pool. To
remove the default router list, use the
no default-router
command.
default-router <Router IP address>
Parameters
Usage Guidelines
The IP address of the router should be on the same subnet as the client subnet.
Example
RFS7000(config-dhcp)#default-router 2.2.2.1
RFS7000(config-dhcp)#
default-router
<router IP address>
Specifies the default router IP address for the network pool.
•
<router IP address> – Router's IP address.
Advertising