Broadcast-tx-speed – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 511
Advertising
Brocade Mobility RFS7000-GR Controller CLI Reference Guide
497
53-1001945-01
Wireless Configuration Commands
20
broadcast-tx-speed
Wireless Configuration Commands
Use this command to configure the rate broadcast and multicast traffic transmitted between the
switch and mobile units.
Syntax
broadcast-tx-speed(range|throughput)
Parameters
Example
RFS7000(config-wireless)#broadcast-tx-speed range
RFS7000(config-wireless)#
RFS7000(config-wireless)#broadcast-tx-speed throughput
RFS7000(config-wireless)#
range
Uses the lowest basic rate. Provides the maximum range.
throughput
Uses the highest basic rate. Provides the maximum throughput (default).
Advertising