Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 337)

Brocade Mobility RFS7000-GR Controller CLI Reference Guide 323
53-1001945-01
Interface Config commands
12
no
Interface Config commands
Use this command to negate a command or set defaults.
Syntax
no [crypto|description|duplex|ip|mac|mtu|port-channel|shutdown|
spanning-tree|speed|static-channel-group|storm-control|switchport|tunnel]
Parameters
The
no
command negates any command associated with it. Wherever required, use the same
parameters associated with the command getting negated.
Example
RFS7000(config-if)#no mtu
RFS7000(config-if)#
RFS7000(config-if)#no spanning-tree link-type
RFS7000(config-if)#
RFS7000(config-if)#no spanning-tree portfast
RFS7000(config-if)#
RFS7000(config-if)#no spanning-tree portfast bpdu-guard
RFS7000(config-if)#
RFS7000(config-if)#no spanning-tree portfast bpdu-filter
RFS7000(config-if)#