Hardware-address – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 434
Advertising
420
Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
DHCP Config Commands
17
hardware-address
Use this command to reserve an IP address (manually) based on a DHCP client’s hardware
address. Use the
no hardware-address
command to remove this from the DHCP pool.
Syntax
hardware-address [XX-XX-XX-XX-XX-XX | XX:XX:XX:XX:XX:XX]
Parameters
Usage Guidelines
This command accepts only hexadecimal values.
Example
RFS7000(config-dhcp)#hardware-address 00:01:23:45:32:22
RFS7000(config-dhcp)#
hardware-address
[XX-XX-XX-XX-XX-XX |
XX:XX:XX:XX:XX:XX]
Configures the client’s hardware address.
•
XX-XX-XX-XX-XX-XX – Dashed-hexadecimal string.
•
XX:XX:XX:XX:XX:XX – Dotted-hexadecimal string.
Advertising