Interfaces – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 64
50
Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
show
2
interfaces
Common to all modes
Syntax
show interfaces [<name>|fe|ge <1-4>|sa <1-4>|
switchport(<name>|fe|ge|sa|tunnel|vlan)|tunnel <1-32>|vlan <1-4094>]
Parameters
Example
RFS7000(config)#show interfaces ge 1
Interface ge1 is UP
Hardware-type: Ethernet, Mode: Layer 2, Address: 00-15-70-38-08-43
Index: 2001, Metric: 1, MTU: 1500, Status-flags: <UP,BROADCAST,RUNNING,MULTIC
AST>
Speed: Admin Auto, Operational 100M, Maximum 1G
Duplex: Admin Auto, Operational Full
Active-medium: Copper
Switchport settings: access, access-vlan: 10
IP-Address: unassigned, primary
Input packets 8900, bytes 887098, dropped 0,
Received 6106 broadcasts, 0 multicasts
Input errors 0, runts 0, giants 0,
CRC 0, frame 0, fragment 0, jabber 0
Output packets 25504, bytes 3134441, dropped 0
Sent 21 broadcasts, 23115 multicasts
Output errors 0, collisions 0, late collisions 0,
Excessive collisions 0
RFS7000(config)#
RFS7000(config)#show interfaces ge 1
Interface ge1
Hardware Type Ethernet, Interface Mode Layer 2, address is 00-15-70-37-fc-8f
index=2001, metric=1, mtu=1500, (HAL-IF) <UP,BROADCAST,MULTICAST>
Speed: Admin Auto, Operational Unknown, Maximum 1G
Duplex: Admin Auto, Operational Unknown
Active Medium: Unknown
Switchport Settings: Mode: Access, Access Vlan: 1
input packets 0, bytes 0, dropped 0, multicast packets 0
input errors 0, length 0, overrun 0, CRC 0, frame 0, fifo 0, missed 0
output packets 0, bytes 0, dropped 0
IFNAME
Interface name.
ge <1-4>
GigabitEthernet interface. Select an index value between 1- 4.
me1 <>
FastEthernet interface.
sa <1- 4>
StaticAggregate interface. Select an index value between 1- 4.
switchport ()
Status of Layer2 interfaces. Select from the following L2 interfaces:
•
ge – GigabitEthernet interface.
•
me1 – FastEthernet interface.
•
sa – StaticAggregate interface.
•
tunnel – Tunnel interface.
•
vlan – VLAN.
vlan <1-4092>
VLAN interface. Select an index value between 1- 4092.