Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 601)

Brocade Mobility RFS7000-GR CLI Reference Guide 587
53-1001945-01
SOLE Config Commands
22
no
SOLE Config Commands
Use this command to negate a SOLE command or set its defaults.
Syntax
no[aap-rssi-update-interval|locate|mobile-unit|redundancy|rssi-filter]
Parameters
Example
RFS7000(config-rtls-sole)#no aap-rssi-update-interval
RFS7000(config-rtls-sole)#
RFS7000(config-rtls-sole)#mobile-unit power-level 2
RFS7000(config-rtls-sole)#
aap-rssi-update-interval Negates AAP probe packet interval configurations.
locate [aeroscout|ekahau
|mobile-units] Negates locationing.
aeroscout –Locates aeroscout tags.
ekahau – Locates ekahau tags.
mobile-units – Locates specified mobile-unit.
mobile-units (power-level) Negates mobile-unit configurations.
redundancy Negates SOLE redundancy configuration.
rssi-filter Sets rssi filter to its default value.