Ap-timeout – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 508
Advertising
494
Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Wireless Configuration Commands
20
ap-timeout
Wireless Configuration Commands
Use this command to change the default inactivity timeout period for access-port(s).
Syntax
ap-timeout <LIST> <40-180>
Parameters
Example
RFS7000(config-wireless)#ap-timeout 1 40
RFS7000(config-wireless)#
LIST <40-180>
An access-ports identified by a single MAC address or by a list of indices. Use
show
wireless ap
to view the AP’s adopted by the MU and their IP addresses.
Note If multiple access-ports are specified, each gets a unique
IP address.
Advertising