Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 470)

456 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
RADIUS Configuration Commands
19
group
RADIUS Configuration Commands
Use this command to configure RADIUS user groups. The CLI moves to a sub-instance
config-radsrv-group
, to create a new group.
The prompt changes from
RFS7000(config-radsrv)#
to
RFS7000(config-radsrv-group)# .
The following table summarizes the RADIUS User Group commands within the
(config-radsrv-group)
sub-instance.
TABLE 16 RADIUS User Group configuration command summary
Command Description Ref.
clrscr Clears the display screen. page 457
end Ends the current mode and changes to the EXEC mode. page 458
exit Ends the current mode and moves to the previous mode. page 459
group Configures RADIUS user group parameters. page 460
guest-group Guest group configuration. page 461
help Describes the interactive help system. page 462
no Negates a command or set its defaults. page 463
policy RADIUS group access policy configuration. page 464
rad-user Adds a RADIUS user to a group. page 465
rate-limit Sets rate limit for group page 466
service Service Commands. page 467
show Shows running system information. page 468