Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 362)

348 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
mst Config commands
13
show
mst Config commands
Use this command to view current system information.
Syntax
show <parameter>
Parameters
Example
RFS7000(config-mst)#show ?aap-wlan-acl wlan based acl
aap-wlan-acl-stats IP filtering wlan based statistics
access-banner Display Access Banner
access-list Internet Protocol (IP)
aclstats Show ACL Statistics information
alarm-log Display all alarms currently in the system
audit-log-filters Display audit log filter rules
autoinstall autoinstall configuration
boot Display boot configuration.
clock Display system clock
commands Show command lists
crypto encryption module
crypto-error-log Display Crypto Error Log
crypto-log Display Crypto Log
debugging Debugging information outputs
dhcp DHCP Server Configuration
environment show environmental information
file Display filesystem information
firewall Wireless firewall
history Display the session command history
interfaces Interface status
ip Internet Protocol (IP)
ldap LDAP server
licenses Show any installed licenses
logging Show logging configuration and buffer
mac Internet Protocol (IP)
mac-address-table Display MAC address table
mac-name Displays the configured MAC Names
management Display L3 Managment Interface name
mobility Display Mobility parameters
ntp Network time protocol
password-encryption password encryption
port Physical/Aggregate port interface
port-channel Portchannel commands
privilege Show current privilege level
protocol-list List of protocols
radius RADIUS configuration commands
role Configure role parameters
rtls Real Time Locating System command
running-config Current Operating configuration
securitymgr Securitymgr parameters
sessions Display current active open connections
? Displays the parameters for which information can be viewed using the show
command.