Switch – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 591
Brocade Mobility RFS7000-GR CLI Reference Guide
577
53-1001945-01
RTLS Config Commands
21
switch
Use this command to configure the switch’s geographical location parameters.
Syntax
switch
[coordinates|geo-coordinates]
switch coordinates
x <0-65535> y <0-65535> z <0-65535>
switch geo-coordinates
longitude <-180.00-80.00>
latitude <-90.00 - 90.00>
Parameters
Example
RFSwitch(config-rtls)#switch coordinates x 121 y 121 z 135
RFSwitch(config-rtls)#
RFSwitch(config-rtls)#switch geo-coordinates longitude 120 latitude 70
RFSwitch(config-rtls)#
coordinates x <0-65535> y
<0-65535> z <0-65535>
Configures switch coordinates within the site
•
x <0-65535> – Configures X coordinate
•
y <0-65535> – Configures Y coordinate
•
z <0-65535> – Configures Z coordinate
longitude <-180.00-80.00>
latitude
<-90.00 - 90.00>
Configures switch geographic coordinates
•
longitude <-180.00-180.00> – Configures longitude, in
degrees, for switch
•
latitude <-90.00-90.00> – Configures latitude, in degrees,
for switch