Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 498
484
Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Wireless Configuration Commands
20
Records mobile unit DHCP state information.
Ends the current mode and moves to the EXEC mode.
Ends the current mode and moves to the previous mode.
Converts broadcast DHCP server responses to unicast response.
Reverts hotspot related configuration.
Describes the interactive help system.
Disables user load balance.
Local MAC authentication list.
Allows manual mapping/un-mapping of WLANs to configured radios.
Configures mobile unit related parameters.
Configures mobility parameters.
Sets a multicast packet limit per second for a VLAN.
Configures watermarks for handling bursts of broadcast/multicast frames.
Negates a command or set its defaults.
Resets nas-id.
Resets nas-port-id.
non-preferred-ap-att
empts-threshold
Reverts the number of attempts after which the switch adopts non preferred
AP to its default value.
Responds to ARP requests on behalf of mobile units.
QoS mappings between the wired and wireless domains.
Radio related commands.
Sets default rate limit per user.
Self healing configuration commands.
Service commands.
Configures Wireless Intrusion Protection System parameters.
Shows running system information.
Wireless LAN related commands.
Allocates radio bandwidth per WLAN.
TABLE 17
Wireless configuration commands
Command
Description
Ref.