Basler Electric DGC-2020HD - Manual (Page 25)

9469300990 Rev B 15
Mounting
DGC-2020HD controllers are delivered in sturdy cartons to prevent shipping damage. Upon receipt of a
unit, check the part number against the requisition and packing list for agreement. Inspect for damage,
and if there is evidence of such, immediately file a claim with the carrier and notify the Basler Electric
regional sales office or your sales representative.
If the device is not installed immediately, store it in the original shipping package in a moisture- and dust-
free environment.
Hardware
The front panel is resistant to moisture, salt fog, humidity, dust, dirt, and chemical contaminants. DGC-
2020HD controllers are mounted using the four permanently attached 10-24 studs. The torque applied to
the mounting hardware should not exceed 20 inch-pounds (2.2 newton meters).
Dimensions
Panel cutting and drilling dimensions are shown in Figure 2. The horizontal drilling measurement of 10.75
inches has a tolerance of +0.01/–0.01 inches. The horizontal cutout measurement of 10.38 inches has a
tolerance of +0.04/–0 inches. The vertical drilling measurement of 7.25 inches has a tolerance of +0.01/–
0.01 inches. The vertical cutout measurement of 6.88 inches has a tolerance of +0.04/–0 inches. Overall
dimensions are shown in Figure 3. All dimensions are shown in inches with millimeters in parenthesis.
Figure 2. Panel Cutting and Drilling Dimensions
10.38
(263.7)
10.75
(273.1)
6.88
(174.8)
7.25
(184.2)
CL
3.44
(87.4)
3.625
(92.1)
(136.5)
5.19
(131.8)
P0071-79
0.25
(6.4)
DGC-2020HD Mounting