Basler Electric DGC-2020HD - Manual (Page 379)

9469300990 Rev B 369
Fault
Code String Description
118 LO ECU SUPPLY VOLTS Power supply voltage too low (limit 1).
119 LOLO ECU SUPPLY VOLTS Power supply voltage too low (limit 2).
120 HI ECU SUPPLY VOLTS Power supply voltage too high (limit 1).
121 HIHI ECU SUPPLY VOLTS Power supply voltage too high (limit 2).
122 HI T ECU Temperature of electronic too high (limit 1).
134 15v POSECU DEFCT Internal electronic fault.
136 15V NEGECU DEFCT Internal electronic fault.
137 L1 5V BUFFR TEST Pressure-sensor fault, pressure-sensor wiring, or internal electronic
fault.
138 SENSOR PWR DEFCT Pressure-sensor fault, pressure-sensor wiring, or internal electronic
fault.
139 L1 TE BUFFR TEST Internal electronic fault.
140 TE BUF ECU DEFCT Internal electronic fault.
141 AL POWER TOO HIGH AL power too high.
142 MCR EXCEEDED 1 HR STR AL MCR exceeded 1 hour.
143 BANK1 ECU DEFECT Internal electronic fault.
144 BANK2 ECU DEFECT Internal electronic fault.
145 15V GOODECU DFCT Internal electronic fault.
147 AD TST1ECU DEFCT Internal electronic fault.
149 AD TST2ECU DEFCT Internal electronic fault.
151 AD TST3ECU DEFCT Internal electronic fault.
170 MI MODULE FAIL Module in maintenance indicator defect.
171 MI NOT ACTIVE WI not active anymore.
172 TBO EXPIRED TBO expired.
173 MODL WRITE LIMIT EEPROM write limit reached.
176 AL LIFE DATA NA No (fitting) LifeData-Backup-System is available within a delay time
after ECU Reset.
177 AL LIFE DATA INCPLT If the ADEC has to restore the LifeData from the backup-system
and at least one checksum is wrong after the upload or the upload
is incomplete, then this failure is set.
180 AL CAN1 NODE LOST Connection to a node on CAN 1 lost.
181 AL CAN2 NODE LOST Connection to a node on CAN 2 lost.
182 AL CAN WRONG PARAMS Incorrect CAN parameter values have been entered.
183 AL CAN NO PU DATA A CAN mode is selected which the communication is initialized
aided of the PU data module. However, required PU data module is
not present or is not valid.
184 AL CAN PUDATA ERR During attempt to copy a received PU data module to Flash
module, a program error occurred.
185 CAN LESS MAILBXS CAN less mailboxes.
186 AL CAN1 BUS OFF CAN controller 1 is in “Bus Off” state.
187 AL CAN1 ERR PASSV CAN controller 1 has signaled a warning.
188 AL CAN2 BUS OFF CAN controller 2 is in “Bus Off” state.
189 AL CAN2 ERROR PASSV CAN controller 2 has signaled a warning.
190 AL EMU PARAM NO SUPPORT EMU parameters are not supported.
201 SD T COOLANT Coolant temperature-sensor defect.
DGC-2020HD MTU Fault Codes