Appendix b: setup mode overview – RKI Instruments EAGLE 2 Manual User Manual
Page 111
EAGLE 2 Operator’s Manual
Overview • 101
Appendix B: Setup Mode
Overview
This appendix describes the EAGLE 2 in Setup Mode. In Setup Mode, you
can:
•
set the date and time
•
set the date format
•
set the battery type
•
configure the channels
•
configure the gas for a catalytic or PID channel
•
set the detection units for the catalytic channel
•
turn the catalytic sensor relative response feature on or off
•
set the alarm points
•
change the alarm latching setting
•
turn the alarm silence feature on or off
•
turn the user/station ID function on or off
•
set the auto calibration values
•
set the backlight delay time
•
turn the automatic fresh air adjust feature on or off
•
set the data logging interval time
•
turn the data logger overwrite feature on or off
•
turn the data log memory clear feature on or off
•
adjust the display contrast
•
turn the calibration reminder feature on or off
•
set the calibration past due action
•
set the calibration interval
•
select the leak check/bar hole mode operation setting
•
set the bar hole measurement time
•
turn the zero follower on or off for each channel
•
set the zero suppression level for each channel (except oxygen)