RKI Instruments EAGLE 2 Manual - Manual (Page 20)

10 • Instrument Description EAGLE 2 Operator’s Manual
Control Buttons
Four control buttons are located below the LCD. They are, from left to right,
POWER ENTER RESET, DISPLAY ADJUST NO, AIR
▲ YES, and
RANGE ▼ SHIFT.
Table 3: EAGLE 2 Control Button Functions
Button Function(s)
POWER ENTER
RESET • turns the EAGLE 2 on and off
• silences and resets audible alarm if Alarm Latching is set to
Latching and Alarm Silence is set to ON
• enters instructions, values, and settings into the EAGLE 2’s
microprocessor
DISPLAY ADJUST
NO • activates Display Mode
• silences and resets audible alarm if Alarm Latching is set to
Latching and Alarm Silence is set to ON
• enters instructions into the EAGLE 2’s microprocessor
AIR ▲ YES • activates the demand zero function (adjusts the EAGLE 2’s
fresh air reading)
• silences and resets audible alarm if Alarm Latching is set to
Latching and Alarm Silence is set to ON
• enters instructions into the EAGLE 2’s microprocessor
• moves the cursor on the LCD up the screen
• increases the value of a parameter available for adjustment
• scrolls through parameter options
RANGE ▼ SHIFT • changes the detection units of the combustible gas channel
(when Catalytic Units is set to CHANGE OK in Setup Mode)
• silences and resets audible alarm if Alarm Latching is set to
Latching and Alarm Silence is set to ON
• enters instructions into the EAGLE 2’s microprocessor
• moves the cursor on the LCD down the screen
• decreases the value of a parameter available for adjustment
• scrolls through parameter options