RKI Instruments EAGLE 2 Manual - Manual (Page 60)

50 • Display Mode EAGLE 2 Operator’s Manual
Select Station ID Screen
This screen displays only if USER/STATION ID in the Setup Mode menu is
set to ON (see “Turning the User/Station ID Function On or Off” on
page 118). Use this screen to select a station ID from the station ID list in the
EAGLE 2’s memory. The current station ID is displayed. A station ID can be
up to 16 characters long. The EAGLE 2 can store up to 128 station IDs.
The station ID provides a way to identify a location where monitoring was
done during a data logging session. If the station ID is changed during an
operating session, a new data session is initiated with the new station ID
attached to it. This allows you to change the station ID during operation and
have each station ID that was used during an operating session saved for the
corresponding data. See the Eagle 2 Data Logger Management Program
Operator’s Manual for a detailed description of data logging and the station
ID.
The station ID list cannot be edited using the EAGLE 2 user interface. The
Eagle 2 Maintenance Data Loader Program is required to define or change
station IDs in the station ID list. For a detailed description of editing the list
of station IDs stored in the EAGLE 2, see the Eagle 2 Maintenance Data
Loader Program Operator’s Manual.
To select a different station ID:
1. With the Select Station ID Screen displayed, press and release the AIR ▲
YES button. A screen appears that includes the current station ID which
is indicated by the cursor next to it.
The station IDs are displayed in groups of six. The previous group of six
is displayed when the cursor is moved up past the top of the LCD. The
next group of six is displayed when the cursor is moved down past the
bottom of the LCD. The list will not “wrap around” to the previous
SELECT
STATION ID?
CURRENT STATION
Pump 2
Pump 2
> Pump 3
Valve 5
----------------
----------------
----------------