RKI Instruments EAGLE 2 Manual - Manual (Page 53)

EAGLE 2 Operator’s Manual Display Mode • 43
If you do not want to change the setting, press and release the DISPLAY
ADJUST NO button and the unit will return to the Gas Display Screen.
Catalytic (LEL) Sensor Screen
This screen appears only when either a TC sensor or an infrared combustible
sensor is installed in an EAGLE 2 along with a catalytic combustible LEL
sensor. See “Appendix F: TC Sensors”, “Appendix H: Infrared Methane
Sensor”, or “Appendix I: Infrared Hydrocarbon Sensor” for a description of
this screen and instructions to use it.
Methane Elimination Mode Screen
This screen displays only if the EAGLE 2 catalytic combustible channel is
setup for one of the gases in the CONFIGURE GASES menu item in Setup
Mode that supports methane elimination (See “Configuring the Combustible
Gas” on page 108).
The standard setup for methane (CH
4
) does not support methane elimination.
When applicable, use this screen to enable and disable the methane
elimination feature. See “Appendix J: Methane Elimination Mode” for more
discussion of the methane elimination feature.
1. With the Methane Elimination Mode Screen displayed, press and release
the AIR ▲ YES or RANGE ▼ SHIFT button to toggle to the desired
setting, ENABLED or DISABLED.
2. Press and release the POWER ENTER RESET button. The unit will save
the setting and proceed to the next menu item.
If you changed the setting and do not want to save the change, press and
release the DISPLAY ADJUST NO button to continue to the next menu
item without saving the change.
Catalytic Sensor Relative Response Screen
This screen displays only if RELATIVE RESPONSE in Setup Mode is set
to ON (see “Updating the Catalytic Sensor Relative Response Setting” on
page 114). Use this screen to temporarily change the gas configuration of the
METHANE ELIMINATION
MODE
DISABLED