RKI Instruments EAGLE 2 Manual - Manual (Page 137)

EAGLE 2 Operator’s Manual Using Setup Mode • 127
Turning the Password Function On or Off
With CHANGE PASSWORD set to ON, the EAGLE 2 prompts you for a
password when you enter Calibration Mode or Setup Mode.
NOTE: If a calibration is due and CAL REMINDER is set to ON and CAL
PAST DUE ACT is set to MUST CALIBRATE, no password will
be required to perform a calibration during startup.
With CHANGE PASSWORD set to OFF (factory setting), no password is
required to enter Calibration Mode or Setup Mode.
1. From the main menu, place the cursor in front of CHANGE
PASSWORD.
2. Press and release POWER ENTER RESET. The Password Protection
Screen appears.
3. Use AIR ▲ YES or RANGE ▼ SHIFT to display the desired setting.
4. If you selected OFF, press and release POWER ENTER RESET to save
the setting and return to the main menu.
If you selected ON, continue with Step 5.
5. Press and release POWER ENTER RESET. The Set Password Screen
appears. The factory set pass password of 0000 is at the bottom of the
screen with the first 0 flashing.
6. Use AIR ▲ YES or RANGE ▼ SHIFT to display a number from 0 to 9.
7. Press and release POWER ENTER RESET to enter the selection and
advance to the next number.
8. Repeat Step 6 and Step 7 to select the remaining numbers. When you
press and release POWER ENTER RESET to enter the last number, the
PASSWORD
PROTECTION
UP/DOWN THEN ENTER
OFF
SET PASSWORD
0000