RKI Instruments EAGLE 2 Manual - Manual (Page 117)

EAGLE 2 Operator’s Manual Using Setup Mode • 107
4. Press and release POWER ENTER RESET. The available configuration
options are shown. In the example below, channel 3 has been selected for
configuration.
5. Use AIR ▲ YES and RANGE ▼ SHIFT to move the cursor next to the
desired configuration for the selected channel. In the example below, the
cursor has been moved next to the NOT USED selection.
The OP1, OP2, and OP3 options are not defined for a standard 4-gas
EAGLE 2. These options are only defined when hardware specific to
optional sensors is factory installed in the EAGLE 2. The “---” in the gas
name field indicates that hardware necessary to support an optional
sensor is not installed. If your EAGLE 2 supports one or more of these
optional sensors, the target gas will appear instead of “---”. See
“Appendix C: Sub PCBs” on page 132 for a description of this optional
hardware and how it affects CHANNEL CONFIGURATION.
6. Press and release POWER ENTER RESET to select the channel
configuration. In the example below, channel 3 has been turned off by
selecting NOT USED.
7. Repeat Step 5 and Step 6 for any other channels you want to configure.
CHANNEL 3 (H2S)
> CAT (CH4)
H2S (H2S)
CO (CO)
CHANNEL 3 (H2S)
> OP1 (---)
OP2 (---)
OP3 (---)
NOT USED
AIR
YES
RANGE
SHIFT
OXY (OXY)
CHANNEL 3 (H2S)
OP1 (---)
OP2 (---)
OP3 (---)
> NOT USED
CONFIGURE CHANNELS
CH1: CAT (CH4)
CH2: OXY (OXY)
> CH3: NOT USED
CH4: CO (CO)