RKI Instruments EAGLE 2 Manual - Manual (Page 29)

EAGLE 2 Operator’s Manual Optional Accessories • 19
• 30 inch stainless steel probe
Figure 10: 30 Inch Stainless Steel Probe
This probe is physically the same as the 30 inch aluminum probe and is
intended for applications where a high level of corrosion resistance is
required in the long probe tube.
• 4 foot stainless steel probe
Figure 11: 4 Foot Stainless Steel Probe
This probe is designed for areas where it is necessary to put the probe tip
in areas that are out of reach for even the 30 inch probes. A stainless steel
probe tube is used because the length of the probe tube requires a high
degree of rigidity. Stainless steel is more rigid than other normally used
materials. A small breather hole near the end of the probe tube prevents
interruption of sampling and a low flow alarm if the probe tip is blocked.
• Barhole probe
Figure 12: Barhole Probe
This probe is designed specifically for barhole testing. See “Appendix K:
Using the EAGLE 2 in Bar Hole Mode” for an in-depth discussion of
using the EAGLE 2 in Bar Hole Mode.