RKI Instruments EAGLE 2 Manual - Manual (Page 114)

104 • Using Setup Mode EAGLE 2 Operator’s Manual
5. If the unit prompts you for the password, enter it by using the AIR ▲
YES and RANGE ▼ SHIFT buttons to select each password number and
then pressing and releasing the POWER ENTER RESET button to enter
it and move on to the next number until all of the numbers are entered.
The main menu displays. It displays six menu items at a time.
6. Use the AIR ▲ YES or RANGE ▼ SHIFT button to move the cursor up
and down the menu items and to view additional menu items. A down
arrow in the lower right corner of the LCD or an up arrow in the upper
right corner of the LCD indicates that there are additional menu items
accessible by moving the cursor down past the last menu item on the
LCD or up past the first menu item on the LCD.
Setting the Date and Time
1. From the main menu, place the cursor next to SET DATE & TIME.
2. Press and release POWER ENTER RESET. The date and time will be
displayed with the last two digits of the year flashing.
3. Use AIR ▲ YES or RANGE ▼ SHIFT to display the desired year.
4. Press and release POWER ENTER RESET to save the setting. The
month setting flashes.
5. Repeat Step 3 and Step 4 to enter the month, day, hours, minutes, and
seconds settings. The main menu displays after you enter the seconds
setting.
Setting the Date Format
The date can be displayed in two ways, month/day/year (factory setting) or
day/month/year.
1. From the main menu, place the cursor next to SET DATE FORMAT.
>SET DATE & TIME
SET DATE FORMAT
SET BATTERY TYPE
CONFIGURE CHANNELS
CONFIGURE GASES
CATALYTIC UNITS
SET DATE & TIME
12/21/2009
11:02:12
MM/DD/YYYY