RKI Instruments EAGLE 2 Manual - Manual (Page 39)

EAGLE 2 Operator’s Manual Measuring Mode, Normal Operation • 29
7. Insert the module’s round plug into the EAGLE 2’s charging jack as
shown in Figure 15 below.
Figure 15: Connecting the EAGLE 2 to the Charger
8. See “Chapter 3: Operation” on page 22 for instructions for start-up and
operation of the EAGLE 2.
9. While the charging module is powering the EAGLE 2, its amber LED
will be off and its green LED will be on.
Measuring Mode, Normal
Operation
When the EAGLE 2 completes its startup sequence, it is in Measuring Mode.
In Measuring Mode the EAGLE 2 continuously monitors the sampled
atmosphere and displays the gas concentrations present for its target gases. In
a low-light environment, press and release any button to turn on the display
backlight. See “Updating the Backlight Delay Setting” on page 119 to
program backlight duration. If the Confirmation Alert feature is turned on in
the Setup Mode menu (see “Updating the Confirmation Alert Setting” on
page 126), the EAGLE 2 beeps periodically to confirm that it’s operating.