RKI Instruments EAGLE 2 Manual - Manual (Page 61)

EAGLE 2 Operator’s Manual Display Mode • 51
screen if the cursor is moved up from the first station ID or to the next
screen if the cursor is moved down from the last station ID. Any of the
station IDs in the list that have not been changed from the factory setting
will be shown as dashes (-).
2. Use the AIR ▲ YES and RANGE ▼ SHIFT buttons to move the cursor
up and down the screen and scroll through the available station IDs to
find the desired station ID.
3. When the desired station ID is displayed, place the cursor next to it, press
and release the POWER ENTER button.
NOTE: To exit the selection screen without saving a change, press and
release the DISPLAY ADJUST NO button. You will return to the
Select Station ID screen without saving the station ID change.
4. The unit will save the selected station ID as the current one and proceed
to the Time in Operation Screen.
Time in Operation Screen
The Time In Operation Screen displays the length of time since the EAGLE 2
was turned on if the lunch break feature is turned off. With the lunch break
feature turned off, the time in operation is reset when the EAGLE 2 is turned
off. See “Updating the Lunch Break Setting” on page 129 for a description of
the lunch break feature.
If the lunch break feature is turned on, the time in operation will only be reset
if you do not choose to resume the peak and TWA measurements when the
EAGLE 2 is turned on in the Resume Measurement Screen described in
Step 7 on page 23 in “Turning On the EAGLE 2”. If you choose to resume
the peak and TWA measurements during startup, the EAGLE 2 will include
the time in operation when the unit was last turned off in the current time in
operation.
TIME IN
OPERATION
45
MINUTES