RKI Instruments EAGLE 2 Manual - Manual (Page 131)

EAGLE 2 Operator’s Manual Using Setup Mode • 121
2. Press and release POWER ENTER RESET. The Data Log Interval
Screen appears.
3. Use AIR ▲ YES or RANGE ▼ SHIFT to display the desired setting.
4. Press and release POWER ENTER RESET to save the setting and return
to the main menu.
Updating the Data Log Overwrite Setting
With DATA LOG OVERWRITE set to ON (factory setting), the EAGLE 2
writes over the oldest data with new data when the data logger memory is
full.
With DATA LOG OVERWRITE set to OFF, the EAGLE 2 stops saving
data to the data logger when the data logger memory is full.
1. From the main menu, place the cursor next to DATA LOG
OVERWRITE.
2. Press and release POWER ENTER RESET. The Overwrite Log Data
Screen appears.
3. Use AIR ▲ YES or RANGE ▼ SHIFT to display the desired setting.
4. Press and release POWER ENTER RESET to save the setting and return
to the main menu.
Updating the Data Log Memory Setting
With DATA LOG MEMORY set to ON (factory setting), the Data Logging
Screen in Display Mode asks whether you want to clear the logged data in
addition to showing the log time remaining (see “Data Logging Screen” on
page 52).
With DATA LOG MEMORY set to OFF, the Data Logging Screen only
DATA LOG INTERVAL
UP/DOWN THEN ENTER
30 SECONDS
OVERWRITE LOG DATA
WHEN MEMORY IS FULL?
UP/DOWN THEN ENTER
ON