RKI Instruments EAGLE 2 Manual - Manual (Page 297)

EAGLE 2 Operator’s Manual Description • 287
Appendix M: Tank Tester Model
The EAGLE 2 Tank Tester model is intended for checking tanks or vessels
that may contain residual hydrocarbon vapors or water or may have been
purged of oxygen. It is supplied as an LEL (catalytic) only unit or an LEL
(catalytic)/oxygen unit. You can also use this model as a standard EAGLE 2
gas monitor by connecting the standard hose and probe and selection Normal
Mode in the Inert Mode Selection Screen.
Description
The tank tester model has an additional socket on the front on the housing to
accommodate connection of the float probe assembly.
Figure 42: EAGLE 2 Tank Tester Version
This model includes the following non-standard components.
Table 34: Alarm Points for Tank Tester Configuration
Alarm 1 Alarm 2
LEL 10% LEL
1100 ppm 50% LEL
5500 ppm
Normal Mode Oxygen Oxy: 19.5% falling Oxy: 23.5% rising
Inert Mode Oxygen Oxy: 5.0% rising Oxy: 10.0% rising
Float
Probe
Socket
Quick Connect
Inlet Fitting
IR Port