Yaskawa iQpump Programming Manual User Manual
Iqpump drive programming manual
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Quick Reference for iQpump (P7U) <0033>
- 0.1 Conventions Used in this Manual
- iQpump Basic Programming Parameters
- A1 Initialization
- b1 Sequence
- b2 DC Braking
- b3 Speed Search
- b4 Delay Timers
- b5 PI Function
- b8 Energy Savings
- C1 Accel/Decel
- C2 S-Curve Acc
- C4 Torque Comp
- C6 Carrier Frequency
- d1 Setpoint and Jog References
- d2 Reference (Speed Command) Limits
- d3 Jump Frequencies
- E1 V/f Pattern
- E2 Motor Setup
- F6 Com OPT Setup
- H1 Digital Inputs
- H2 Digital Outputs
- H3 Analog Inputs
- H4 Analog Outputs
- H5 Serial Communications Setup
- Using Modbus Communication
- Modbus Communication Configuration
- Communication Specifications
- Communication Connection Terminal
- Procedure for Setting Up Communication
- Modbus Function Code Details
- Modbus Data Tables
- Reference Data
- Modbus Self-Diagnosis
- L1 Motor Overload
- L2 Momentary Power Loss Ride-thru Function
- L3 Stall Prevention
- L4 Speed Command Loss Detection
- L5 Fault Restart
- L6 Torque Detection
- L8 Hardware Protection
- n1 Hunting Prevention
- o1 Monitor Configuration
- o2 Key Selections
- o3 Digital Operator Copy Function
- P1 Pump Basic
- P2 Pump Protection
- P3 Pump Protection
- P4 Pump Protection
- P5 Pump Protection
- Pump Tuning
- System Response During Normal Automatic Operation (P3-12)
- Friction Compensation for Single Pump Systems (P3-13, P3-14)
- Friction Compensation for Multi-Pump Systems (P3-07, P3-08)
- T1 Auto-Tuning
- Parameter List
- Monitor List
- Fault Trace List
- Fault History List
- Factory Default Settings