Client mode configuration example, Network requirements, Configuration procedure – H3C Technologies H3C MSR 50 User Manual
Page 129
108
Client mode configuration example
Network requirements
As shown in
, the router accesses the wireless network as a client. The Ethernet interface of the
router connects to multiple hosts or printers in the wired network, and thus the wired network is connected
to the wireless network through the router.
•
The AP accesses the wired LAN, and the router accesses the AP as a client.
•
The router accesses the wireless service psk by passing the RSN(CCMP)+PSK authentication.
•
Client with MAC address 0014-6c8a-43ff also accesses the wireless service psk.
Figure 102 Network diagram
Configuration procedure
1.
Enable the client mode:
a.
Select Interface Setup > Wireless Service > Client Mode from the navigation tree.
b.
Click Connect Setup.
Internet
Gateway
AP
Router
PC
Printer
Client
Client
Client
PSK
PSK
PSK