H3C Technologies H3C MSR 50 - Manual (Page 738)

353
Item Description
Ignore the Sending-Complete
Information Element in Setup
Messages
• Enable for outgoing direction—Configure the ISDN protocol to send Setup
messages without the Sending-Complete Information Element when
placing a call.
• Enable for incoming direction—Configure the ISDN protocol to ignore the
Sending-Complete Information Element in Setup messages when receiving
a call.
• Enable for bidirectional directions—Configure the ISDN protocol to ignore
the Sending-Complete Information Element in Setup messages when
receiving a call, and to send Setup messages without the
Sending-Complete Information Element when placing a call.
• Disable (default)—Configure the ISDN not to ignore the Sending-Complete
Information Element in Setup messages. When the data exchange
performed between the device and an ISDN switch, for an incoming call,
the device checks the received Setup messages for the Sending-Complete
Information Element to determine whether or not the number is received
completely. If a Setup message does contain the Sending-Complete
Information Element, the number is not received completely. For outgoing
calls, a Setup message containing the Sending-Complete Information
Element indicates that the number is sent completely.
Q.921 Permanent Link
Configure the Q.921 permanent link function:
• Enable—The BRI interface sets up a data link connection automatically
and maintains the connection even when no calls are received from the
network layer. If the two-tei mode is also enabled on the interface, two
such connections are present.
• Disable—Disable the Q.921 permanent link function on the BRI interface.
This parameter is available only when the User Side Mode option in the ISDN
Working Mode area is selected.
ISDN two-tei
• Enable—Each call on the BRI interface uses a different EI.
• Disable—All calls on all the B channels on the BRI interface use one TEI
value.
ISDN Link Mode
• Point-to-Multipoint—A BRI interface operating on the network side can
have multiple end devices attached to it.
• Point-to-Point—Configure the BRI interface operates in point-to-point
mode.
BSV Permanent Active State at
the Physical Layer
• Enable—Specify an ISDN BRI interface to be in the permanent active state
at the physical layer.
• Disable—The BRI interfaces operating on the network side are not in the
permanent active state at the physical layer.
This parameter is available only when the Network Side Mode option in the
ISDN Working Mode area is selected.
BSV Remote Powering
• Enable—Enable remote powering on an ISDN BRI interface.
• Disable—Disable remote powering on an ISDN BRI interface.
This parameter is available only when the Network Side Mode option in the
ISDN Working Mode area is selected.
ISDN Sliding Window Size Set the sliding window size on an ISDN BRI interface.
ISDN T302 Timer Duration Configure the duration of the ISDN protocol Layer 3 timer T302.