H3C Technologies H3C MSR 50 - Manual (Page 268)

247
Configuring QoS
The Web interface provides the following QoS configuration functions:
• Configuring subnet limit
• Configuring advanced limit
• Configuring advanced queue
Overview
Quality of Service (QoS) is a concept concerning service demand and supply. It reflects the ability to
meet customer needs. Generally, QoS focuses on improving services under certain conditions rather than
grading services precisely.
In an Internet, QoS evaluates the ability of the network to forward packets of different services. You can
base the evaluation on different criteria because the network provides various services. Generally, QoS
refers to the ability to provide improved service by solving the core issues such as delay, jitter, and packet
loss ratio in the packet forwarding process.
Through the Web interface, you can configure the following QoS features:
• Subnet limit
• Advanced limit
• Advanced queue
Subnet limit
Subnet limit enables you to regulate the specification of traffic entering or leaving a device based on
source/destination IP address. Packets conforming to the specification can pass through, and packets
exceeding the specification are dropped. In this way, the network resources are protected.
Advanced limit
Similar to subnet limit, advanced limit also implements traffic policing at the IP layer. They differ in that:
• Advanced limit can classify traffic based on time range, packet precedence, protocol type, and
port number, and provide more granular services.
• In addition to permitting traffic conforming to the specification to pass through, advanced limit can
also set IP precedence, differentiated service code point (DSCP) value, and 802.1p priority for
packets as required.
For more information about IP precedence, DSCP values, and 802.1p priority, see " Appendix Packet
precedencesAppendix Packet ."
Advanced queue
Advanced queue offers the following functions: