H3C Technologies H3C MSR 50 - Manual (Page 360)

339
Item Description
Realtime Accounting Attempts
Set the maximum number of attempts for sending a real-time accounting
request.
Unit for Data Flows
Specify the unit for data flows sent to the RADIUS server: byte, kilo-byte,
mega-byte, or giga-byte.
Unit for Packets
Specify the unit for data packets sent to the RADIUS server: one-packet,
kilo-packet, mega-packet, or giga-packet.
VPN
Specify the VPN to which the RADIUS scheme belongs.
This setting is effective to all RADIUS authentication servers and accounting
servers configured in the RADIUS scheme, but the VPN individually specified
for a RADIUS authentication or accounting server takes priority.
Security Policy Server Specify the IP address of the security policy server.
RADIUS Packet Source IP
Specify the source IP address for the device to use in RADIUS packets sent to
the RADIUS server.
H3C recommends using a loopback interface address instead of a physical
interface address as the source IP address. If the physical interface is down,
the response packets from the server cannot reach the device.
Buffer stop-accounting packets
Stop-Accounting Attempts
Enable or disable buffering of stop-accounting requests for which no
responses are received, and set the maximum number of attempts for
sending stop-accounting requests.
Send accounting-on packets
Accounting-On Interval
Accounting-On Attempts
Enable or disable the accounting-on feature, and set the interval and the
maximum number of attempts for sending accounting-on packets.
The accounting-on feature enables a device to send accounting-on packets to
RADIUS servers after it reboots, making the servers forcedly log out users
who logged in through the device before the reboot.
IMPORTANT:
When enabling the accounting-on feature on a device for the first time, you
must save the configuration so that the feature takes effect after the device
reboots.
Attribute
Interpretation Enable or disable the device to interpret the RADIUS class attribute as CAR
parameters.
Adding RADIUS servers
1. In the RADIUS Server Configuration area, click Add.