H3C Technologies H3C MSR 50 - Manual (Page 234)

213
Recommended configuration procedure
Configuring the DHCP server
Task Remarks
Configuration guidelines
If multiple
VLAN interfaces sharing one MAC address request IP
addresses using DHCP, the DHCP server cannot be a Windows
2000 server or a Windows 2003 server.
1. To remove a DHCP server group that is
associated with multiple interfaces, cancel
the associations first.
Enabling DHCP
Required.
Enable DHCP globally.
Disabled by default.
Configuring the DHCP server on an interface
Optional.
For detailed configuration, see
"
Configuring DHCP interface setup ."
Enabled by default.
IMPORTANT:
The DHCP server configuration is
supported only on a Layer 3 Ethernet
interface (or subinterface), virtual Ethernet
interface, VLAN interface, Layer 3
aggregate interface, serial interface, ATM
interface, MP-group interface, or
loopback interface.
Configuring a static address pool for the DHCP server
Required.
An address pool can be either static or
dynamic, but not both.
IMPORTANT:
When a DHCP client tries to obtain an IP
address through a DHCP relay agent, an
IP address pool on the same network
segment as the DHCP relay agent interface
must be configured. Otherwise, the DHCP
client fails to obtain an IP address.
Configuring a dynamic address pool for the DHCP server