H3C Technologies H3C MSR 50 - Manual (Page 184)

163
Configuring MAC address filtering
Use MAC address filtering to match MAC addresses of hosts accessing the network through the device,
and deny or permit hosts with matched MAC addresses to access the network through the device.
MAC address filtering is only applicable to the outgoing direction of Layer 3 Ethernet interfaces and
dialer interfaces.
Configuring the MAC address filtering type
Select Security Setup > MAC Address Filtering from the navigation tree to enter the MAC address filtering
configuration page.
Figure 165 MAC address filtering
Table 93 Configuration item
Item Description
filtering type
Select a MAC address filtering type:
• Disable MAC address filtering.
• Permit access to the Internet—Enables MAC address filtering to permit only the hosts whose
MAC addresses are on the MAC address list below to access the network through the
device.
• Deny access to the Internet—Enables MAC address filtering to deny the hosts whose MAC
addresses are on the MAC address list below from accessing the network through the
device.
IMPORTANT:
A MAC address list appears at the lower part of the page after you select Permit access to the
Internet or Deny access to the Internet.
Configuring the MAC addresses to be filtered
Select Security Setup > MAC Address Filtering from the navigation tree to enter the MAC address filtering
configuration page, as shown in Figure 165 . Select Permit access to the Internet or Deny access to the