H3C Technologies H3C MSR 50 - Manual (Page 661)

276
Figure 667 Call routing binding page of number substitution list 21102
10. Select Apply Call Routing Binding Rule to Calling Numbers for Binding Mode.
11. Select call route 10.
12. Click Apply.
Configuring Router A
# Set the IP address of the Ethernet interface to 1.1.1.1.
# Add a call route: specify the call route ID as 1010, the destination number as …., and the trunk route
line as FXO line 1/0 on the call route configuration page. In addition, you need to select the Send All
Digits of a Called Number option in the Called Number Sending Mode area when you configure the
advanced settings of this call route; you also need to select the Enable option in the Hunt Group area
when you configure the call services of this call route.
# Add a call route: specify the call route ID as 2010, the destination number as ...., and to the trunk route
line as FXO line 1/1 on the call route configuration page. In addition, you need to select the Send All
Digits of a Called Number option in the Called Number Sending Mode area when you configure the
advanced settings of this call route; you also need to select the Enable option in the Hunt Group area
when you configure the call services of this call route.
# Add number substitution rule list 101 for called numbers of incoming calls.
Select Voice Management > Dial Plan > Number Substitution from the navigation tree, and click Add to
access the number substitution configuration page.