Configuring router b – H3C Technologies H3C MSR 50 User Manual
Page 395
10
b.
Click Add.
The IPsec connection configuration page appears.
c.
Enter map1 as the IPsec connection name.
d.
Select interface Ethernet0/1.
e.
Enter 2.2.3.1 as the remote gateway IP address.
f.
Select the Pre-Shared-Key box, and then enter abcde in both the Key and Confirm Key fields.
g.
In the Selector area, select Characteristics of Traffic as the selector type.
h.
Specify 10.1.1.0/0.0.0.255 as the source address/wildcard. Specify 10.1.2.0/0.0.0.255
as the destination address/wildcard.
i.
Select Enable for RRI. Enter 2.2.2.2 as the next hop.
j.
Click Apply.
Figure 374 Adding an IPsec connection
Configuring Router B
1.
Assign IP addresses to the interfaces. (Details not shown.)
2.
Configure a static route to Host A:
a.
Select Advanced > Route Setup from the navigation tree.
b.
Click the Create tab.
The page as shown in
appears.
c.
Enter 10.1.1.0 as the destination IP address.
d.
Enter 24 as the mask.
e.
Select Interface and then select Ethernet0/1 as the interface.