Rockwell Automation 25B PowerFlex 520-Series Adjustable Frequency AC Drive User Manual - Manual (Page 66)

66 Rockwell Automation Publication 520-UM001G-EN-E - September 2014
Chapter 3 Programming and Parameters
• Bit Parameters
Bit parameters have five individual digits associated with features or
conditions. If the digit is 0, the feature is off or the condition is false. If the
digit is 1, the feature is on or the condition is true.
Some parameters are marked as follows.
Parameter Groups For an alphabetical listing of parameters, see Parameter Cross Reference by Name
on page 140 .
= Stop drive before changing this parameter.
= 32 bit parameter. Parameters marked 32 bit will have two parameter numbers ([Step Units x] and
[Step Units F x]) when using RS485 communications and programming software. The second parameter
number is shown only in the Parameter Groups and Parameter Cross Reference by Name tables for reference.
= Parameter is specific to PowerFlex 525 drives only.
32
PF 525
Basic Display
Output Freq b001
Commanded Freq b002
Output Current b003
Output Voltage b004
DC Bus Voltage b005
Drive Status b006
Fault 1 Code b007
Fault 2 Code b008
Fault 3 Code b009
Process Display b010
Control Source b012
Contrl In Status b013
Dig In Status b014
Output RPM b015
Output Speed b016
Output Power b017
Power Saved b018
Elapsed Run Time b019
Average Power b020
Elapsed kWh b021
Elapsed MWh b022
Energy Saved b023
Accum kWh Sav b024
Accum Cost Sav b025
Accum CO2 Sav b026
Drive Temp b027
Control Temp b028
Control SW Ver b029
Basic Program
Language P030
Motor NP Volts P031
Motor NP Hertz P032
Motor OL Current P033
Motor NP FLA P034
Motor NP Poles P035
Motor NP RPM P036
Motor NP Power P037
Voltage Class P038
Torque Perf Mode P039
Autotune P040
Accel Time 1 P041
Decel Time 1 P042
Minimum Freq P043
Maximum Freq P044
Stop Mode P045
Start Source 1 P046
Speed Reference1 P047
Start Source 2 P048
Speed Reference2 P049
Start Source 3 P050
Speed Reference3 P051
Average kWh Cost P052
Reset To Defalts P053
Terminal Blocks
DigIn TermBlk 02 t062
DigIn TermBlk 03 t063
2-Wire Mode t064
DigIn TermBlk 05 t065
DigIn TermBlk 06 t066
DigIn TermBlk 07
(1)
t067
DigIn TermBlk 08
(1)
t068
Opto Out1 Sel
(1)
t069
Opto Out1 Level
(1)
t070
Opto Out2 Sel (1) t072
Opto Out2 Level (1) t073
Opto Out Logic
(1)
t075
Relay Out1 Sel t076
Relay Out1 Level t077
Relay 1 On Time t079
Relay 1 Off Time t080
Relay Out2 Sel
(1)
t081
Relay Out2 Level
(1)
t082
Relay 2 On Time (1) t084
Relay 2 Off Time (1) t085
EM Brk Off Delay t086
EM Brk On Delay t087
Analog Out Sel
(1)
t088
Analog Out High
(1)
t089
Anlg Out Setpt
(1)
t090
Anlg In 0-10V Lo t091
Anlg In 0-10V Hi t092
10V Bipolar Enbl (1) t093
Anlg In V Loss t094
Anlg In4-20mA Lo t095
Anlg In4-20mA Hi t096
Anlg In mA Loss t097
Anlg Loss Delay t098
Analog In Filter t099
Sleep-Wake Sel t100
Sleep Level t101
Sleep Time t102
Wake Level t103
Wake Time t104
Safety Open En
(1)
t105
Communications
Comm Write Mode C121
Cmd Stat Select (1) C122
RS485 Data Rate C123
RS485 Node Addr C124
Comm Loss Action C125
Comm Loss Time C126
RS485 Format C127
EN Addr Sel
(1)
C128
EN IP Addr Cfg 1 (1) C129
EN IP Addr Cfg 2 (1) C130
EN IP Addr Cfg 3 (1) C131
EN IP Addr Cfg 4
(1)
C132
EN Subnet Cfg 1
(1)
C133
EN Subnet Cfg 2
(1)
C134
EN Subnet Cfg 3
(1)
C135
EN Subnet Cfg 4 (1) C136
EN Gateway Cfg 1 (1) C137
EN Gateway Cfg 2
(1)
C138
EN Gateway Cfg 3
(1)
C139
EN Gateway Cfg 4 (1) C140
EN Rate Cfg (1) C141
EN Comm Flt Actn (1) C143
EN Idle Flt Actn
(1)
C144
EN Flt Cfg Logic
(1)
C145
EN Flt Cfg Ref
(1)
C146
EN Flt Cfg DL 1
(1)
C147
EN Flt Cfg DL 2 (1) C148
EN Flt Cfg DL 3 (1) C149
EN Flt Cfg DL 4
(1)
C150
EN Data In 1
(1)
C153
EN Data In 2 (1) C154
EN Data In 3 (1) C155
EN Data In 4 (1) C156
EN Data Out 1
(1)
C157
EN Data Out 2
(1)
C158
EN Data Out 3
(1)
C159
EN Data Out 4
(1)
C160
Opt Data In 1 C161
Opt Data In 2 C162
Opt Data In 3 C163
Opt Data In 4 C164
Opt Data Out 1 C165
Opt Data Out 2 C166
Opt Data Out 3 C167
Opt Data Out 4 C168
MultiDrv Sel C169
Drv 1 Addr C171
Drv 2 Addr C172
Drv 3 Addr C173
Drv 4 Addr C174
DSI I/O Cfg C175
(1) Parameter is specific to PowerFlex 525 drives only.