Rockwell Automation 1766-Lxxxx MicroLogix 1400 Programmable Controllers User Manual - Manual (Page 115)

Rockwell Automation Publication 1766-UM001H-EN-P - May 2014 73
Using the LCD Chapter 5
7. Press OK to apply the changes. Then, the new value OFF (0) is applied.
Note that the target bit, “0/0” in this example, is flashing. The cursor is
moved automatically to the target bit position.
You can identify this change of data value is reflected to your
RSLogix 500/RSLogix Micro programming software.
TIP When the cursor is at the data value position, press the Down key to
change the data value of a bit from ON (1) to OFF (0). Press the Up key
to change from OFF (0) to ON (1).
After changing the data value of a target bit, press the OK key to apply
the changes or press the ESC key to discard the changes.