Rockwell Automation 1766-Lxxxx MicroLogix 1400 Programmable Controllers User Manual - Manual (Page 212)

172 Rockwell Automation Publication 1766-UM001H-EN-P - May 2014
Appendix D Using ControlFLASH to Upgrade Your Operating System
For the IP address to be configured using the ControlFLASH BOOTP
server, the BOOTP settings should be enabled in the controller, see
step 2
of Prepare the Controller for Firmware Upgrade on page 168.
8. The AB_SNMP - BOOTP Server Running dialog box may take several
seconds or minutes to appear.
You may need to wait several seconds before you are returned to the
AB_SNMP.DLL - Enter IP Address dialog box. Within several seconds,
the Device Identification box displays the processor's current revision
information.