Rockwell Automation 1766-Lxxxx MicroLogix 1400 Programmable Controllers User Manual User Manual
Page 145
Advertising
Rockwell Automation Publication 1766-UM001H-EN-P - May 2014
103
Using the LCD Chapter 5
1. On the Main Menu screen, select Advanced Set by using the Up and Down
keys on the LCD keypad, as shown below. If the menu items shown in the
figure below are not displayed on the Main Menu screen, you need to scroll
down the screen by pressing the Down key.
2. Press the OK key on the LCD keypad. The Advanced Settings Menu
screen is displayed, as shown below.
3. If ENET Cfg is selected, press the OK key. If not, select ENET Cfg using
the Up and Down keys, and then press the OK key.
4. If Protocol setup is selected, press the OK key. If not, select Protocol setup
using the Up and Down keys, and then press the OK key.
Advertising
This manual is related to the following products: