Rockwell Automation 1766-Lxxxx MicroLogix 1400 Programmable Controllers User Manual User Manual
Page 120
78
Rockwell Automation Publication 1766-UM001H-EN-P - May 2014
Chapter 5 Using the LCD
8. Press the Left key once. Then, press the Down key once. The sign digit will
change to “-”, as shown below. Note that “-” is still flashing, which means
the cursor is still at the data value position.
9. Press OK to apply the changes. Then, the new value -1300 is applied. Note
that the target word “0”, which is right next to “N7:”, is flashing. The cursor
is moved automatically to the target word position.
You can identify this change of data value is reflected to your RSLogix
500/RSLogix Micro programming software, as shown below.
TIP
After changing the data value of a target word, press the OK key to
apply the changes or press the ESC key to discard the changes.