Rockwell Automation 1766-Lxxxx MicroLogix 1400 Programmable Controllers User Manual - Manual (Page 37)

Rockwell Automation Publication 1766-UM001H-EN-P - May 2014 23
Install Your Controller Chapter 2
Panel Mounting
Mount to panel using #8 or M4 screws. To install your controller using mounting
screws:
1. Remove the mounting template from inside the back cover of the
MicroLogix 1400 Programmable Controllers Installation Instructions,
publication
1766-IN001 .
2. Secure the template to the mounting surface. (Make sure your controller is
spaced properly. See Controller and Expansion I/O Spacing on page 20.)
3. Drill holes through the template.
4. Remove the mounting template.
5. Mount the controller.
6. Leave the protective debris shield in place until you are finished wiring the
controller and any other devices.
ESC
OK
open closed 44519
44520
ESC
OK
Mounting Template
44521