Loading communication eeprom, Lcd setup – Rockwell Automation 1766-Lxxxx MicroLogix 1400 Programmable Controllers User Manual User Manual
Page 155
Advertising
Rockwell Automation Publication 1766-UM001H-EN-P - May 2014
113
Using the LCD Chapter 5
Loading communication EEPROM
Follow these steps to load user programs and data from the memory module to
the controller's memory.
1. Select Load from MM to load user programs and data.
2. If your controller is in a non-executing mode, skip to the next step.
Otherwise switch your controller to a non-executing mode.
3. This screen appears if the load from the memory module is complete. Press
the OK key to go back to executing mode.
LCD setup
In the LCD Setup screen, you can configure the contrast value and backlight for
the LCD.
TIP
For more information on transferring data to and from memory
modules, see Memory Module Operation on page 159.
Advertising
This manual is related to the following products: