Rockwell Automation 1766-Lxxxx MicroLogix 1400 Programmable Controllers User Manual - Manual (Page 99)

Rockwell Automation Publication 1766-UM001H-EN-P - May 2014 85
Communication Connections Chapter 4
Ethernet Connections
The Ethernet connector, Channel 1, is an RJ45, 10/100Base-T connector. The
pin-out for the connector is shown below.
Pin Pin Name
1 Tx+
2 Tx-
3 Rx+
4 not used by 10/100Base-T
5 not used by 10/100Base-T
6 Rx-
7 not used by 10/100Base-T
8 not used by 10/100Base-T
TIP For more information on using ethernet cables with MicroLogix 1400,
see.
8 7 6 5 4 3 2 1 1 2 3 4 5 6 7 8
End view of RJ 45 Plug Looking into a RJ45 Jack