Rockwell Automation 1766-Lxxxx MicroLogix 1400 Programmable Controllers User Manual - Manual (Page 133)

Rockwell Automation Publication 1766-UM001H-EN-P - May 2014 91
Using the LCD Chapter 5
If a user defined screen is used in your application program, the LCD
screen is displayed, as shown below, according to the specific instructions
used in your program.
3. Hold down the ESC key more than 3 seconds to return to the Main
Menu screen, as shown below.
Configuring Advanced
Settings With the Advanced Set menu, which is a sub-menu under the main menu of the
LCD, you can use the following features:
• changing Key In mode
• using communications toggle functionality
• configuring Ethernet Network Configuration
• using trim pots
• viewing system information
• viewing fault code
• saving/loading Communication EEPROM
• changing LCD contrast and backlight
• viewing/changing the Modbus RTU Slave Node address
You can access to the Advanced Set Menu screen, as shown below, by selecting
Advanced Set on the Main Menu screen.
COM
M
0
COMM
1
DCOM
M
BA
T.
LO
U-
DI
SP
COM
M
2