Rockwell Automation 1766-Lxxxx MicroLogix 1400 Programmable Controllers User Manual User Manual
Page 119
Rockwell Automation Publication 1766-UM001H-EN-P - May 2014
77
Using the LCD Chapter 5
4. The current data value (ON) of the N7:0 word is displayed. Note that the
target word “0”, which is right next to “N7:”, is flashing, which means the
cursor is at the target word position.
5. We will change the data value of the N7:0 word to the negative decimal
value -1300. First, press OK to move the cursor to the data value position.
Then, the last digit of “+00000” will be flashing, which means the cursor is
at the data value position.
6. Press the Left key twice. Then, the cursor will position at the third digit.
Press the Up key three times to change the third digit to 3.
7. Press the Left key once. Then, press the Up key once. The second digit will
change to “1”. Note that “1” is still flashing, which means the cursor is still
at the data value position.