Yaskawa D1000 Series Power Regenerative Converter - Manual (Page 10)

10 YASKAWA ELECTRIC TOEP C710656 07C YASKAWA Power Regenerative Converter - D1000 Instruction Manual
i.1 Preface
i.1 Preface
Yaskawa manufactures products used as components in a wide variety of industrial systems and equipment. The selection
and application of Yaskawa products remain the responsibility of the equipment manufacturer or end user. Yaskawa
accepts no responsibility for the way its products are incorporated into the final system design. Under no circumstances
should any Yaskawa product be incorporated into any product or design as the exclusive or sole safety control. Without
exception, all controls should be designed to detect faults dynamically and fail safely under all circumstances. All systems
or equipment designed to incorporate a product manufactured by Yaskawa must be supplied to the end user with
appropriate warnings and instructions as to the safe use and operation of that part. Any warnings provided by Yaskawa
must be promptly provided to the end user. Yaskawa offers an express warranty only as to the quality of its products in
conforming to standards and specifications published in the Yaskawa manual. NO OTHER WARRANTY, EXPRESS OR
IMPLIED, IS OFFERED. Yaskawa assumes no liability for any personal injury, property damage, losses, or claims
arising from misapplication of its products.
This manual is designed to ensure correct and suitable application of D1000-Series power regenerative converters. Read
this manual before attempting to install, operate, maintain, or inspect a converter and keep it in a safe, convenient location
for future reference. Be sure you understand all precautions and safety information before attempting application.
◆ Applicable Documentation
The following manuals are available for D1000 series:
◆ Symbols
Note: Indicates a supplement or precaution that does not cause converter damage.
◆ Terms and Abbreviations
• Conveter: YASKAWA D1000 Series Power Regenerative Converter
• Drive: Yaskawa 1000-Series Drive
• BCD: Binary Coded Decimal
• H: Hexadecimal Number Format
• IGBT: Insulated Gate Bipolar Transistor
◆ Trademarks
• MECHATROLINK-I/MECHATROLINK-II are trademarks of MECHATROLINK Members Association (MMA).
• Other companies and product names mentioned in this manual are trademarks of those companies.
YASKAWA D1000 Series
Power Regenerative Converter
Instruction Manual (TOEP C710656 07)
This guide is packaged together with the product and contains basic information required to install and wire the converter.
It also gives an fault diagnostics, maintenance, and parameter settings. The purpose of this guide is to prepare the converter
for a trial run with an application and for basic operation.
CIMR-AA2A0021FAA 200V 3Phase 5.5kW/3.7kW
S/N:
危 険 据え付け、運転の前には必ず取扱説明書を読むこと。
通電中および電源遮断後5分以内はフロントカバー
を外さない事。
400V 級インバータの場合は、電源の中性点が接地 されていることを確認すること。( 対応）
保守・点検、配線を行う場合は、出力側開閉器を
遮断後5分待って実施してください。
けが．感電のおそれがあります。
高温注意
インバータ上部、両側面は高温になります。
触らないでください。
● ● ●
●
AVERTISSMENT NPJT31470-1 Lire le manuel avant l'installation. Attendre 5 minutes après la coupure de l'alimentation, pour permettre la décharge des condensateurs. Pour répondre aux exigences , s assurer que le neutre soit relié à la terre, pour la série 400V. Après avoir déconnécte la protection entre le driver et le moteur, veuillez patienter 5 minutes avain d’effectuer une opération de montage ou de câblage du variateur.
Risque de décharge électrique.
Surfaces Chaudes Dessus et cotés du boitier Peuvent devenir chaud. Ne Pas toucher.
WARNING Read manual before installing. Wait 5 minutes for capacitor discharge after disconnecting power supply. To conform to requirements, make sure to ground the supply neutral for 400V class. After opening the manual switch between the drive and motor, please wait 5 minutes before inspecting, performing maintenance or wiring the drive.
Risk of electric shock.
Hot surfaces
Top and Side surfaces may become hot. Do not touch.
● ● ● ●
●
● ● ● ●
●
● ● ● ● ●
LO
RE
F2 F1
ESC
RUN STOP ENTER RESET
ALM DIGITAL OPERATOR JVOP-180
TOEP_C710656_07C_2_0.book 10 ページ ２０１５年１月９日 金曜日 午後６時２３分